LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Automatic, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1354 (Antilock Brake System) >> Repair Instructions >> Brake Modulator Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the brake pressure modulator assembly to the bracket. Secure with 3 nuts.

    Tighten:  Tighten the brake modulator assembly nuts to 5 N.m (42 lb in).

    2. Fig 1: Brake Modulator Nut
    GM819497Courtesy of GENERAL MOTORS CORP.
  2. Install the brake pressure modulator assembly and bracket. Secure with nut (1).

    Tighten:  Tighten the brake modulator bracket nut to 19 N.m (14 lb ft).

    3. Fig 2: Brake Modulator Assembly, Modulator Bracket And Bolts
    GM819496Courtesy of GENERAL MOTORS CORP.
  3. Install 2 bolts (2) to the brake pressure modulator bracket (3).

    Tighten:  Tighten the brake modulator bracket bolts to 19 N.m (14 lb in).

  4. Remove the plugs from brake pipes and connect the brake pipes to the brake modulator assembly (1).

    Tighten:  Tighten the brake pipe fittings nuts to 15 N.m (11 lb in).

  5. Connect the EBCM electrical connector.
  6. Bleed the brake system. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
  7. Perform Diagnostic System Check - ABS .
scientia non olet · About LEMON Manuals