Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connector And Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Secure the amplifier to the vehicle with the 3 bolts (1, 3,4).
Tighten: Tighten the 3 bolts to 10 N.m (89 lb in).
Connect the electrical connector (2).
Install the front passenger seat. Refer to Seat Replacement - Front Bucket in Seats.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.