LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Automatic, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Side Impact Sensor And Fasteners
    GM819434Courtesy of GENERAL MOTORS CORP.
  1. Install the side impact sensor (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the side impact sensor fasteners (2).

    Tighten:  Tighten the fasteners to 8 N.m (71 lb in).

  3. Install the side impact sensor electrical connector.
  4. Install the front seat belt retractor. Refer to Seat Belt Retractor Replacement - Left Front or Seat Belt Retractor Replacement - Right Front in Seat Belts.
  5. Install the center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  6. Install the rear door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
  7. Install the front door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zones .
scientia non olet · About LEMON Manuals