LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Automatic, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inflatable Restraint Side Impact Sensor And Pretensioner Wiring Harness Connectors
    GM628394Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, and other contaminants from the mounting surface.
  2. Install the inflatable restraint side impact sensor (2) to the center pillar.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the 2 fasteners (1) to the side impact sensor.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  4. Connect the yellow 2-way harness connector (4) to the side impact sensor.
  5. Install the CPA to the yellow 2-way connector (4).
  6. Install the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 6 .
scientia non olet · About LEMON Manuals