Installation Procedure

Install the electronic lock module (1) to the steering column housing.
Install the electronic lock module(1) mounting screws (2).

Fig 1: Electronic Lock Module & Mounting Screws
Courtesy of GENERAL MOTORS CORP.
Install the ignition switch (2) to the electronic lock module (2).

Fig 2: Key Alarm Switch Connector
Courtesy of GENERAL MOTORS CORP.
Connect the passlock electrical connector (1) from the lock module.
Rotate the key alarm switch connector to the electronic lock module.

Fig 3: Key Alarm Switch Connector
Courtesy of GENERAL MOTORS CORP.
Snap the electric park lock (2) onto the electronic lock module (1) floorshift only.

Fig 4: Electric Park Lock & Electronic Lock Module
Courtesy of GENERAL MOTORS CORP.
Connect the electric park lock (1) electrical connector (2) floorshift only.

Fig 5: Electric Park Lock & Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install park lock cable (1) to the electronic lock module, column shift only.

Fig 6: Park Lock Cable
Courtesy of GENERAL MOTORS CORP.
Install the following parts to the steering shaft:
1. Turn signal cancel cam (3)
2. Shaft lock shield (4).
Fig 7: Turn Signal Cancel Cam & Shaft Lock Shield
Courtesy of GENERAL MOTORS CORP.
Install the J 23653-SIR to the steering shaft and compress the shaft lock shield.
Install the lock shield retainer to the steering column shaft.
Remove the J 23653-SIR from the steering column shaft.
Install the steering column shrouds. Refer to Steering Column Trim Covers Replacement - On Vehicle .

Fig 8: Installing Lock Shield Using J 23653-SIR
Courtesy of GENERAL MOTORS CORP.