LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting Systems >> Repair Instructions >> Lamp Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Lamp Module Connector
    GM828425Courtesy of GENERAL MOTORS COMPANY
  1. Install the lamp module to the connector until fully seated.
    2. IMPORTANT:

    Do not tape past the line where the cooling fins begin. Taping around the fins will result in the module overheating.

  2. Install a new electrical tape around the module in order to secure the module to the IP wire harness.
  3. Connect all the electrical connectors.
    4. Fig 2: View Of Air Deflector Louver, Retainers & Switches
    GM676695Courtesy of GENERAL MOTORS COMPANY
  4. Install the head lamp switch/4WD shift button housing to the IP so that the retainers are fully seated.
  5. Install the IP trim bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gauges and Console.
scientia non olet · About LEMON Manuals