LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls - 4.3L - Repair Instructions) >> Repair Instructions >> Fuel Tank Fuel Pump Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Sender Assembly
    GM371000Courtesy of GENERAL MOTORS COMPANY
  1. Install the fuel pressure sensor (1).
  2. Install the fuel level sensor (3).
  3. Install the fuel level sensor retaining clip (4).
  4. Connect the fuel level sensor electrical connector (7).
  5. Connect the fuel level sensor electrical connector retaining clip (6).
  6. Connect the fuel pump electrical connector (5).
    IMPORTANT:

    Always install a new fuel strainer when replacing the fuel tank fuel pump module.

  7. Install a new fuel strainer (2) in the same position as noted during disassembly. Push the strainer on the bottom of the fuel sender until the strainer is fully seated.
  8. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
scientia non olet · About LEMON Manuals