Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Use a standard valve core tool in order to install a new valve core (2).
- Tighten the fuel filler cap.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Auxiliary Battery) , Battery Negative Cable Disconnection and Connection (Single Battery) in Engine Electrical.
- Inspect for leaks using the following procedure:
- Turn ON the ignition, with the engine OFF, for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition with the engine OFF.
- Inspect for fuel leaks.
- Install the fuel pressure connection valve cap (3).