LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls - 4.3L - Repair Instructions) >> Repair Instructions >> Accelerator Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accelerator Cable Tangs, Pedal Lever & Cable Retainer
    GM372959Courtesy of GENERAL MOTORS COMPANY
  1. Install the accelerator pedal.
  2. Install the end bushings to the pivot shaft.
  3. Install the end bushing retaining clips.
  4. Install the accelerator cable through the slot in the accelerator pedal lever (2).
  5. Seat the retainer (3) in the accelerator pedal lever (2).
  6. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal. The throttle should operate freely without bind between full closed throttle and wide open throttle.
  7. Install the left instrument panel insulator.
scientia non olet · About LEMON Manuals