Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the glow plug into cylinder 8.
Tighten: Tighten the glow plugs to 17 N.m (13 lb ft).
Install the lead wire to cylinder 8 glow plug.
Install the glow plugs into cylinders 2, 4, and 6 by reaching through the right front wheel well.
Tighten: Tighten the glow plugs to 17 N.m (13 lb ft).

Fig 1: Glow Plug Lead Wires

Courtesy of GENERAL MOTORS CORP.

Install lead wire to glow plug 6.
- Slide the shroud over the wire lead and fasten to the studs.
- Repeat Step 4 for the cylinder 4 glow plug.
  Tighten: Tighten the heat shroud nuts to 23 N.m (17 lb ft).
Install the wires for glow plugs in cylinders 4 and 6 to connectors at the wire harness.
Install the lead wire for cylinder 2 glow plug.
Install the splash shield in the right front wheel well.
Inspect the wire routing, making sure the lead wires are not rubbing against the exhaust manifold or any part that may harm the wire insulation.
Install the right front tire.