Installation Procedure
- Record the 10-digit STID number from the label on the new module.
- Install the VIU to the bracket.
- Connect the electrical connectors.
- Refer to Fastener Notice
.
Install the 2 screws (1) securing the VIU to the bracket.
Tighten
Tighten the screws to 9 N.m (80 lb in).
- Install the I/P trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
- Reconfigure the OnStar® system. Refer to OnStar Reconfiguration (Without TIS 2 Web Gen.3 and prior) .
IMPORTANT:
After replacing the VIU, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair.