LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Jimmy 4D Utility, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Servicing >> Removal & Installation >> 2-4 Servo >> Installation

2-4 Servo: Installation

  1. Install the new seals on the pistons and the servo cover. Lubricate the seals with clean ATF. Install the 2-4 servo assembly into the 2-4 servo bore. Install the servo cover and O-ring seal. Install the servo cover compressor.
  2. Tighten the bolt on the servo cover compressor to compress the servo cover. See Fig 1 . Install the servo cover retaining ring. Remove the servo cover compressor from the oil pan flange.
  3. Install the oil pan bolt. Tighten the oil pan bolt to specification. See TORQUE SPECIFICATIONS  . Lower the vehicle. Fill transmission with appropriate fluid to proper level. See LUBRICATION  .
Fig 1: Installing Servo Cover Compressor
G92J12574Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Servo Cover Retaining Ring
G00089865Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Servo O-Ring
G00089866Courtesy of GENERAL MOTORS CORP.
Fig 4: Inspecting Servo Components For Damage
G00089867Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals