Cruise Control Functional Switches

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 GMC Yukon XL, 2000 GMC Yukon, 2000 GMC Sierra, 2000 Chevrolet Tahoe, and 2000 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Multifunction lever may also be referred to as combination switch.

Functional control switches are located on end of multifunction lever, which also serves as a turn signal lever. Functional control switches include a SET button and a sliding main switch with OFF, ON and R/A positions.

OFF

System disengages when switch is turned to OFF position.

ON

System is ready to be set when switch is turned to ON position.

SET (Set/Coast)

Spring-loaded SET button engages cruise. During engagement, if SET button is pressed and held, vehicle decelerates (cruise disengages) until button is released. When button is released, cruise engages and maintains new set speed. By quickly pressing and releasing (tapping) this button, the set speed is "tapped" down in one MPH increments.

R/A (Resume/Accelerate)

Spring-loaded R/A switch will not initially set cruise speed, but when cruise has been disengaged by braking, momentarily sliding this switch to R/A position will cause cruise to resume previously set speed. This is the resume function. Accelerate function occurs when R/A switch is held in position for more than one second. This causes the vehicle to accelerate until switch is released. When released, system maintains new set speed. By quickly pressing and releasing (tapping) this switch, the set speed is "tapped" up in one MPH increments.