DTC U1300: Class 2 Data Link Low: Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 GMC Yukon XL, 2000 GMC Yukon, 2000 GMC Sierra, 2000 Chevrolet Tahoe, and 2000 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Modules connected to the class 2 serial data line monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged between modules. In addition, node alive (state of health) messages are transmitted by each module on the class 2 serial data line about once every 2 seconds.

When a module detects no messages and a low voltage on the class 2 serial data line for about 3 seconds, DTC U1300 is set, the setting of all other class 2 communication DTCs in inhibited and the module uses default values for all parameters received on the class 2 serial data line. A current DTC U1300 will clear when a valid class 2 message is detected on serial data line or at the end of the current ignition cycle. A history DTC U1300 can only be cleared using scan tool.