LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1998 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System >> Programming >> Auto Learn

Auto Learn

NOTE: This procedure allows relearning of PASSLOCK(R) module or VCM learned data code after replacement of PASSLOCK(R) module, PASSLOCK(R) sensor or VCM. DTC B3031 will set when entering programming mode.
  1. Clear all DTCs. See scan tool manufacturer's instructions. Turn ignition off. Replace component(s) as necessary.
  2. With transmission in Park (A/T) or Neutral (M/T), turn ignition switch momentarily to START position (DO NOT  start engine). Leave ignition in RUN position (engine off). If PASSLOCK(R) sensor was replaced, SECURITY indicator light will flash for 10 minutes. If PASSLOCK(R) module was replaced, SECURITY indicator light will flash for a few seconds, then stay on for 10 minutes. If VCM was replaced with a new VCM, vehicle may start and procedure may not be needed. If replacement VCM was used even momentarily, SECURITY indicator light will flash for a few seconds, then stay on for 10 minutes. After 10 minutes, when light turns off, turn ignition switch to OFF position for 10 seconds.
  3. Repeat step 2) twice more. Auto learn procedure will be completed during next start attempt. Clear all DTCs. If VCM was replaced, reprogram VCM. See appropriate TESTS W/CODES article in ENGINE PERFORMANCE section.
scientia non olet · About LEMON Manuals