LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1996 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Tests W/Codes - P Series (6.5L Diesel) >> Diagnostic Trouble Codes >> DTC P0220 - Accelerator Pedal Position (App) Sensor 2 Circuit >> Diagnostic Procedures

Diagnostic Procedures

  1. Perform Powertrain On-Board Diagnostic (OBD) System Check. After performing OBD system check, go to next step.
  2. Turn ignition off. Disconnect APP sensor connector. Turn ignition on, with engine off. Using DVOM, check voltage between ground and 5-volt reference circuits (terminals "G", "D" and "E") of APP sensor connectors. If voltage on all circuits is 4.8 volts, go to step 4). If voltage on all circuits is not 4.8 volts, go to next step.
  3. DTC is intermittent. If no additional DTCs are set, see DIAGNOSTIC AIDS. If any additional DTCs are set, go to applicable DTC test.
  4. Turn ignition off. Disconnect PCM connector. Check for short to ground in 5-volt reference circuits. Repair as necessary. If short to ground was present in 5-volt reference circuits, go to step 6). If short to ground was not present in 5-volt reference circuits, go to next step.
  5. Replace PCM. Go to next step.
  6. Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter DTC P0220. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2).
  7. Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTC(s) are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals