LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> Forward Control 6.2 J, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Controls - Remove/Install/Overhaul - 5.9L Diesel) >> Fuel System >> Fuel Transfer Pump >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cables. Remove starter. Disconnect fuel lines at fuel transfer pump and fuel heater. Remove bolts, fuel transfer pump along with fuel heater and gasket.
    CAUTION: Bolts must be tighten evenly when installing fuel transfer pump to prevent damage to fuel transfer pump.
  2. To install, ensure gasket sealing surfaces are clean. Using NEW gasket, install fuel transfer pump and fuel heater on cylinder block. Install bolts in fuel transfer pump. Tighten bolts evenly to specification. See TORQUE SPECIFICATIONS .
  3. Tighten fuel lines to specification. Install starter and negative battery cables. Bleed low-pressure fuel lines. See FUEL LINE BLEEDING  under FUEL SYSTEM.
scientia non olet · About LEMON Manuals