LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> Forward Control 4.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Controls - Remove/Install/Overhaul - 5.9L Diesel) >> Fuel System >> Fuel Injector >> Installation

Fuel Injector: Installation

WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean fuel injector bore on cylinder head with Brush (3822509). Install NEW Copper sealing ring on spray tip of fuel injector. Coat fuel injector retaining nut and top of fuel injector body with anti-seize compound.
    CAUTION: Ensure protruding side of fuel injector aligns with notch area of cylinder head before tightening fuel injector retaining nut.
  2. Install fuel injector in original position. Ensure protruding side of fuel injector aligns with notch area of cylinder head. Install and tighten fuel injector retaining nut to specification. See TORQUE SPECIFICATIONS .
  3. Once fuel injector retaining nut is tightened, install NEW "O" ring (if equipped) in groove on top of fuel injector. To install remaining components, reverse removal procedure using NEW seal washers. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Bleed high-pressure fuel lines. See FUEL LINE BLEEDING  under FUEL SYSTEM.
scientia non olet · About LEMON Manuals