LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1986 >> Forward Control 6.2 J, Standard >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column >> Removal & Installation >> Steering Columns >> Installation ("P" Series)

Installation ("P" Series)

  1. Adjust lower bearing preload to allow steering shaft end play. See ADJUSTMENTS  in this article. Tighten shaft clamp on pot joint bolt.
  2. Carefully insert lower end of column assembly into hole in floor pan. Guide steering shaft into universal yoke, lining up marks made at removal. Install yoke pinch bolt and tighten to 35 ft. lbs. (47 N.m). Pinch bolt must pass through shaft undercut.
  3. Position and attach lower clamp mounting bracket to firewall. Position steering column protrusions against floor pan bracket while aligning protrusion on clutch and brake pedal support with index slot on column jacket. Install column-to-bracket clamp and tighten bolt.
    NOTE: DO NOT  allow toe pan bracket to override protrusions on steering column jacket.
  4. Position steering column-to-dash panel bracket. Install and tighten bolts. Install seal at floor pan, then install bracket screws and tighten. Install dash panel trim plate, if equipped. Connect transmission shift linkage on column shift models.
  5. On all models, connect wiring harness. On models with standard column and A/T, connect conductor tube for transmission indicator to instrument panel. On all models, install steering wheel and connect battery negative cable.
scientia non olet · About LEMON Manuals