Checking Fluid Level
CAUTION:
DO NOT overfill. One pint of fluid will raise level from "ADD 1 PT." to "FULL HOT" mark on dipstick with a hot transmission.
Bring engine and transmission to normal operating temperature. With vehicle parked on a level surface and engine at idle, move selector lever through all positions, ending in "P". Remove dipstick, wipe clean and check fluid level. Fluid level should be between "ADD 1 PINT" ("ADD") and "FULL" marks on dipstick.
If vehicle has been operated for an extended period of time at high speed, in city traffic, or pulling a trailer, and accurate fluid level cannot be immediately determined. Transmission must cool for about 30 minutes after vehicle is parked, before fluid level is checked.