Steering Gear: Jeep

Remove intermediate shaft to worm shaft coupling clamp bolt and disconnect intermediate shaft. Remove pitman arm nut and washer. Pull pitman arm off shaft with puller (J-6632).
On Wagoneer, Cherokee and Truck models, remove steering gear-to-frame rail bolts and remove steering gear from vehicle.
On "CJ" and Scrambler models, raise left side of vehicle slightly to release tension from left front spring. Place safety stand under frame. Remove bolts securing steering gear lower bracket to frame. Remove bolts securing steering gear upper bracket to crossmember. Remove steering gear from vehicle. Remove brackets if necessary.
To install, apply Loctite to frame end crossmember bolts, reverse removal procedure.