TPMS Reminder Reset - Procedure 30
If refilling a low tire, no specific reset procedure is required. All warnings are extinguished once the TPMS receives a signal that all tires are properly inflated.
TPMS sensors are mounted onto each tire and wheel assembly, excluding the spare tire and wheel assembly. Each TPMS sensor has a unique identification code. The identification code needs to be matched to a new tire/wheel position after rotating the vehicle's tires or replacing one or more of the TPMS sensors. The TPMS sensor matching process should also be performed after replacing a spare tire with a road tire containing the TPMS sensor. The malfunction light and the DIC message should go off at the next ignition cycle. The sensors are matched to the tire/wheel positions, using a TPMS relearn tool.
- Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
- Set the parking brake.
- Put the vehicle in ON/ RUN and place the vehicle in P (Park).
- If the Driver Information Center (DIC) display is minimized, press the SELECT knob to maximize it. See Fig 1.
- Use the SELECT knob to scroll to the Tire Pressure display screen.
- Press and hold the SELECT knob for five seconds to begin the sensor matching process. A message displays confirming to begin the process.
- Use the SELECT knob to select YES with the highlighted selection, and press the SELECT knob again to confirm the selection.
- The horn sounds twice to signal the receiver is in relearn mode and the TIRE LEARNING ACTIVE message displays on the DIC screen.
- Starting with left front tire, hold a tire sensor activation tool against the side wall of the tire, within 3 inches of the valve stem. Activate tool until a horn chirp sounds.
- After horn chirp has sounded and the right turn signal has illuminated, proceed to the next 3 sensors in the following order: right front, right rear and left rear.
- After left rear sensor has been learned, a double horn chirp will sound, indicating all 4 sensor IDs have been learned. Turn ignition switch to OFF position to exit Learn Mode.