Installation ("P" Models Only)

Applying 50 ft.lbs. force on steering wheel end of steering shaft, adjust lower bearing preload to allow steering shaft end play. Tighten shaft clamp on pot joint bolt. Carefully insert lower end of column assembly into hole in floor pan. Guide steering shaft into universal yoke, lining up marks made at removal. Install yoke pinch bolt and tighten. Pinch bolt must pass through shaft undercut.
Position and attach lower clamp mounting bracket to firewall. Locate steering column protrusions against floor pan bracket while at the same time, aligning protrusion on clutch and brake pedal support with index slot on column jacket. Install column-to-bracket clamp and tighten bolt.
NOTE: Do not allow toe pan bracket to override protrusions on steering column jacket.
Position steering column-to-dash panel bracket and install and tighten bolts. Install seal at floor pan, then install bracket screws and tighten. Install dash panel trim plate, if equipped. Connect transmission shift linkage on column shift models.
On all models, connect directional signal wiring harness. On non-tilt columns with automatic transmissions, connect conductor tube for transmission indicator to instrument panel. On all models, install steering wheel and connect battery ground cable.