LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2024 >> F-150 Lightning Flash >> Repair and Diagnosis >> External Pages >> Different car >> Section 1057 (Roof Opening Panel) >> General Procedures >> Power Roof Opening Panel Initialization

Power Roof Opening Panel Initialization

WARNING: This page is about a different car, the 2022 Ford F-150 Lightning and 2022 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding

Initialization 

WARNING: Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.
NOTE: The roof opening panel motor must be initialized when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass (fixed panoramic or front sliding) has been removed or adjusted, or if the roof opening panel frame has been removed.
NOTE: If the roof opening panel motors are removed and then reinstalled, they must be returned to the same location (driver side or passenger side) they were removed from, with the roof opening panel in the same state (opened or closed) they were in when the motors were removed, or the system will not function correctly and re-intialization may not be possible.
NOTE: Carrying out the initialization procedure will initialize both the roof opening panel glass motor and the shield (sunshade) motor.
NOTE: A fully functional system features One Touch Open and One Touch Close. If these features are not available, the system requires initialization.
NOTE: The battery must be fully charged while performing the initialization procedure. The procedure cannot be completed if the battery is in a low state of charge.
  1. Open the driver side door and leave it open for the entire procedure.
  2. Without stepping on the brake pedal, press the PUSH TO START button to enter Accessory Mode.
  3. NOTE: This step is only applicable if the One Touch Open and One Touch Close features are functioning.

    Move the sliding glass and shield both to the fully closed position.

  4. NOTE: Locate the Glass Vent and Shield Open switches on the overhead console and be prepared two use both thumbs to press them simultaneously.
    NOTE: Complete the following within 3 seconds:

    • Without stepping on the brake pedal, press the PUSH TO START button twice in rapid succession to switch Accessory Mode OFF and then immediately back to ON.

    • Use both thumbs to press and then quickly release the Glass Vent and the Shield Open switches simultaneously. The shield will then initialize and remain closed while the sliding glass initializes.

  5. If the procedure is interrupted before completion, switch Accessory Mode from ON to OFF, wait 5 seconds with Accessory Mode OFF, and repeat the entire procedure.
  6. Verify successful initialization by opening the shield with the Shield Open switch. Repeat the procedure if the One Touch Open and One Touch Close features are not available.
scientia non olet · About LEMON Manuals