Pinpoint Test AO: PSCM (Power Steering Control Module) DTC (Diagnostic Trouble Code) U0155:00 Lost Communication With Instrument Panel Cluster (IPC) Control Module

NOTE: Refer to Steering GSB for additional connector and wiring inspection tips.

Refer to POWER STEERING CONTROLS Wiring Diagrams for schematic and connector information.

Normal Operation and Fault Conditions

Description
The PSCM monitors the HS-CAN messages when the ignition has been on for more than 5 seconds, the voltage to the PSCM is greater than 10 volts and there are no Diagnostic Trouble Codes (DTCs) present inhibiting PSCM operation.
For additional information on the messages sent to the PSCM from the IPC, REFER to: Power Steering - System Operation and Component Description .

Pinpoint Test Applicability
This test applies to PSCMDTC U0155 Lost Communication with the IPC only. It does not apply to any other module except the PSCM.

DTC Diagnostic Strategy
If the module DTC list results in a large number of Diagnostic Trouble Codes (DTCs), diagnose all module hard faults first (C102D, C1B00, C200B, C200C, C200D, U2011 and U3000) before diagnosing any network faults (lost communication or invalid data). If voltage concern Diagnostic Trouble Codes (DTCs) are present, diagnose those after any module hard faults and before any network faults. Diagnose all current and active Diagnostic Trouble Codes (DTCs) before diagnosing any historic Diagnostic Trouble Codes (DTCs).

Pinpoint Test Purpose
To verify the PSCM wiring harness and connectors are OK. This test checks the connectors and wiring from the PSCM 3 pin connector at the steering gear to the in-line connector in the engine compartment. If these circuits are working correctly, the test then directs to check the IPC and wiring harness.

Diagnostic Aids
Do not install a new PSCM as part of the repair for a PSCMDTC U0155:00.
DTC U0155:00 indicates a possible failure of the HS-CAN which can be due to a circuit fault in the HS-CAN, the PSCM wiring harness or a IPC concern.

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Condition
PSCM U0155:00	Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information	This DTC sets when the PSCM does not receive the IPC messages within a certain time frame. This can occur if the IPC wiring harness or electrical connectors are loose or damaged, or if the vehicle battery state of charge levels are low.

Possible Sources

NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector.