Engine Mount: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the engine mount and the 3 bolts.
- Tighten to 90 Nm (66 lb-ft).
- Install the 4 engine mount nuts.
- Tighten to 63 Nm (46 lb-ft).
- Install the degas bottle. For additional information, refer to Engine Cooling .
- Connect the coolant hose to the coolant inlet pipe.
- Remove the hose clamp pliers.
- Attach the A/C line retainer to the shock tower bracket.
- If equipped, install the skid plate and the 10 retainers.
- Tighten to 70 Nm (52 lb-ft).
- If equipped, install the underbody shield and attach the 4 retainers.