Removal And Installation
NOTE:
Removal steps in this procedure may contain installation details.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking And Lifting .
- Loosen the 4 retainers and remove the underbody shield.
- Detach the 2 wiring harness retainers from the valve cover stud bolts.
- Detach the CAC inlet pipe.
- Using a floor jack and a wooden block, support the engine.
- Remove the 4 nuts, the 3 bolts and the engine mount.
- To install, tighten the bolts to 90 Nm (66 lb-ft) and the nuts to 125 Nm (92 lb-ft).
- To install, reverse the removal procedure.