LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2019 >> Taurus SE, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Drive Axle/Differential) >> Removal And Installation >> Axle Assembly >> Removal

Axle Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the driveshaft assembly. For additional information, refer to Driveshaft .
  2. Remove the rear halfshafts. For additional information, refer to Halfshaft .
  3. Remove the stabilizer bar. For additional information, refer to Stabilizer Bar .
  4. Position a suitable transmission hydraulic jack to the axle housing.

    • Securely strap the jack to the housing.

  5. Remove the 4 differential housing-to-front insulator bracket bolts.
  6. Remove the 6 side insulator bracket-to-rear axle differential bolts.
  7. Lower the axle to gain clearance to the Active Torque Coupling (ATC) electrical connector and disconnect the connector.
  8. Remove the axle assembly.
scientia non olet · About LEMON Manuals