| B11DB:02 |
Battery Monitoring Module "A", General Signal Failure |
GO to Pinpoint Test A |
| B11DB:08 |
Battery Monitoring Module "A", Bus Signal / Message Failure |
GO to Pinpoint Test A |
| B11DB:11 |
Battery Monitoring Module "A", Circuit Short To Ground |
GO to Pinpoint Test A |
| B11DB:49 |
Battery Monitoring Module "A", Internal Electronic Failure |
CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the BCM self test. If Diagnostic Trouble Codes (DTCs) B11DB:49 is retrieved, INSTALL new Battery Monitoring Sensor. REFER to: Battery Monitoring Sensor
. |
| B11DB:55 |
Battery Monitoring Module "A", Not Configured |
CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. INSTALL As-Built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. |
| B11DB:83 |
Battery Monitoring Module "A": Value of Signal Protection Calculation Incorrect |
GO to Pinpoint Test A |
| B11DB:96 |
Battery Monitoring Module hardware fault |
GO to Pinpoint Test A |
| B11DB:9A |
Battery Monitoring Module "A", Component or System Operating Conditions |
GO to Pinpoint Test A |
| B130C:12 |
Load Shed Control: Circuit Short To Battery |
The BCM monitors an unused load shed relay control circuit. If this DTC sets, disregard and diagnose other Diagnostic Trouble Codes (DTCs) or symptoms as required. |
| B130C:14 |
Load Shed Control: Circuit Short To Ground or Open |
The BCM monitors an unused load shed relay control circuit. If this DTC sets, disregard and diagnose other Diagnostic Trouble Codes (DTCs) or symptoms as required. |
| U1007:00 |
Lost communication with Battery Monitoring Sensor "A": No Sub Type Information |
GO to Pinpoint Test A |
| All Other DTCs |
-- |
REFER to: Body Control Module (BCM)
. |