LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Transit Connect Titanium >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> MULTIFUNCTION Electronic Modules >> Diagnosis And Testing >> Body Control Module (BCM) >> Pinpoint Tests >> Pinpoint Test O : U3003:17 >> Pinpoint Test O : U3003:17

Pinpoint Test O : U3003:17

  1. O1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) P0563 (PCM (POWERTRAIN CONTROL MODULE)), U3003:17 OR U3006:17 SET IN OTHER MODULES

    NOTE: U3003:17 may be stored in the module memory due to previous battery charging or vehicle jump starting events.

    • Ignition ON.

    • Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.

    Is DTC U3003:17, U3006:17 or P0563 (PCM) set in more than one module? 

    Yes  DIAGNOSE the over charging condition. REFER to Charging System - 2.5L Duratec (125kW/170PS) .
    No  GO to  O2

  2. O2 CHECK THE BATTERY VOLTAGE

    • Turn off all interior/exterior lights and accessories.

    • Start and run the engine at approximately 2, 000 RPM for 3 minutes while monitoring the battery voltage.

    Does the battery voltage rise to 18.7 volts or higher? 

    Yes  DIAGNOSE the over charging condition. REFER to Charging System - 2.5L Duratec (125kW/170PS) .
    No  GO to  O3

  3. O3 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U3003:17

    • Turn the engine off.

    • Ignition ON.

    • Using a diagnostic scan tool, perform the self-test.

    • Clear the Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    • Carry out the BCM self-test.

    Is DTC U3003:17 still present? 

    Yes  Refer to BCM Hardware Testing .
    No  The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals