Toe Adjustment - Front

1.

Using alignment equipment and the manufacturer's instructions, measure the front toe.

2.

Start the engine and center the steering wheel.

3.

Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

4.

Remove the steering gear bellows clamps.

GFD81513

Courtesy of FORD MOTOR COMPANY

5.

Loosen the nuts.

GFD81514

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.

Rotate the tie rods as necessary to adjust the toe setting.

7.

Tighten the tie-rod jam nuts to 63 Nm (46 lb-ft).

GFD81514

Courtesy of FORD MOTOR COMPANY

8.

Recheck the toe settings and adjust as necessary.

9.

Install the steering gear bellows clamps.