LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Taurus SHO >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 6F35) >> Removal And Installation >> Transaxle Case Bushing >> Installation

Transaxle Case Bushing: Installation

WARNING: This page is about a different variant/trim than selected.

  1. 1.

    Clean the halfshaft bushing area of the transmission case.

  1. 2.

    Assemble 307-664 and 205-153 T80T-4000-W and install a new bushing on 307-664.
GFD84223Courtesy of FORD MOTOR COMPANY

  1. 3.

    Place a small amount of Retaining Compound on only the outside of the entire outer circumference of the new red Teflon ® coated bushing before installation.
GFD84224Courtesy of FORD MOTOR COMPANY

  1. 4.

    Using 307-664 and 205-153 T80T-4000-W, install the new bushing in the transmission case.
GFD84225Courtesy of FORD MOTOR COMPANY

  1. 5.

    Install a new LH halfshaft seal. Refer to Halfshaft Seal - LH .

  1. 6.

    Install the drain plug.
    • 12 Nm (106 lb-in).
GFD84149Courtesy of FORD MOTOR COMPANY

  1. 7.

    NOTE: Do not install the underbody shield at this time.

    Fill the transmission with transmission fluid. Start the engine and let it run for 5 minutes. Refer to Transmission Fluid Drain and Refill .

  1. 8.

    Remove the drain plug and drain the transmission fluid a second time.
    • 12 Nm (106 lb-in).
GFD84149Courtesy of FORD MOTOR COMPANY

  1. 9.

    Fill the transmission with transmission fluid. Refer to Transmission Fluid Drain and Refill .
scientia non olet · About LEMON Manuals