In-Vehicle Repair: Flexplate: Installation

1.

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Install the flexplate and the 8 bolts.
- Tighten in the sequence shown to 80 Nm (59 lb-ft).

Fig 1: Flexplate Tightening Sequence

GFD82426

Courtesy of FORD MOTOR COMPANY

2.

Install the transaxle. For additional information, refer to Automatic Transmission 6F50/6F55 .

3.

Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.