LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Fusion Titanium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Supplemental Restraint System - General Procedures, Removal And Installation) >> Removal And Installation >> Occupant Classification System Module (OCSM) >> Removal

Occupant Classification System Module (OCSM): Removal

WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use care when handling the front passenger seat and track assembly. Dropping the assembly, placing excessive weight on or sitting on a front passenger seat that is not secured in the vehicle may result in damaged seat components. Failure to follow these instructions may result in incorrect operation of the occupant classification system (OCS) and increases the risk of serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

  1. 1.

    Raise the passenger seat to its highest position.

  1. 2.

    Depower the SRS. For additional information. Refer to Supplemental Restraint System (SRS) Depowering and Repowering .

  1. 3.

    Disconnect the Occupant Classification System Module (OCSM) electrical connector.

  1. 4.

    Remove the 2 screws and OCSM.

  1. 5.

    To install, reverse the removal procedure.

  1. 6.

    Repower the SRS.

    Do not  prove out the SRS at this time. For additional information, Refer to Supplemental Restraint System (SRS) Depowering and Repowering .

  1. 7.

    Carry out the Occupant Classification System(OCS) System Reset procedure. For additional information. Refer to Occupant Classification Sensor (OCS) System Reset .
scientia non olet · About LEMON Manuals