Wipers & Washers DTCS: SCCM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure | INSTALL a new wiper/washer switch. Refer to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B1008:09 is retrieved again, INSTALL a new SCCM. Refer to: Steering Column Control Module (SCCM) . |
| B1051:09 | Front Washer Switch: Component Failure | INSTALL a new wiper/washer switch. Refer to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B1008:09 is retrieved again, INSTALL a new SCCM. Refer to: Steering Column Control Module (SCCM) . |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. Refer to: Rain Sensor . |
| B10AD:55 | Rain Sensor: Not Configured | PERFORM the Programmable Module Installation (PMI) for the SCCM using as built data. |
| B1131:02 | Wiper motor module: General Signal Failure | GO to Pinpoint Test B |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:11 | Wiper motor module: Circuit Short to Ground | GO to Pinpoint Test B |
| B1131:49 | Wiper motor module: Internal Electronic Failure | If only the passenger side wiper motor is inoperative, INSTALL a new passenger side windshield wiper motor. Refer to: Windshield Wiper Motor
. If both wiper motors are inoperative, INSTALL a new driver side windshield wiper motor. Refer to: Windshield Wiper Motor . |
| B1131:55 | Wiper motor module: Not Configured | PERFORM the Programmable Module Installation (PMI) for the SCCM using as built data. |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | DIAGNOSE the symptom present with the wiper/washer system. REFER to Symptom Chart(s) . |
| B12F7:09 | Single Wipe Switch: Component Failure | INSTALL a new wiper/washer switch. Refer to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B1008:09 is retrieved again, INSTALL a new SCCM. Refer to: Steering Column Control Module (SCCM) . |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Steering Wheel and Column Electrical Components . |