DTC C1B00: Steering Angle Sensor: Description

While the ignition is ON and the voltage supply to the PSCM is above 9 volts, the module monitors the motor inside the EPAS gear to calculate the relative and actual steering wheel angle. This value is transmitted to other modules over the HS-CAN.

• DTC C1B00:2F (Steering Angle Sensor: Signal Erratic) - If the signal is calculated to be outside the expected range, DTC C1B00:2F is set. If the tie rods (inner or outer) have been incorrectly installed or if the vehicle has sustained damage to the EPAS gear or associated steering or suspension components, DTC C1B00:2F may set.
• DTC C1B00:62 (Steering Angle Sensor: Signal Compare Failure) - If the calculated signal does not match other sensor input, DTC C1B00:62 is set.