Selector Lever Assembly: Removal
WARNING: This page is about a different car, the 2015 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Apply the parking brake.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Open the floor console stowage bin lid.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
On both sides.Detach the clips and remove the floor console upper finish panels.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Detach the clips and remove the lower center stack finish panel.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Detach the clips, disconnect the electrical connectors and remove the floor console upper trim panel.
 Courtesy of FORD MOTOR COMPANY
|
- 6.
Release the clips, lift the selector lever bezel up and disconnect the electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 7.
On both sides. Release the clips, remove the LH and the RH lower floor console side trim panels.
 Courtesy of FORD MOTOR COMPANY
|
- 8.
Remove the bolts and the media hub bin.
 Courtesy of FORD MOTOR COMPANY
|
- 9.
Remove the bolts and the floor console support bracket.Torque
: 22 lb.in (2.5 Nm)
 Courtesy of FORD MOTOR COMPANY
|
- 10.
NOTE:
Do not pull or pry on the selector lever cable or the selector lever cable end may be damaged. Use a screwdriver and turn the screwdriver as shown in illustration to pry the cable end off the post as close to the post as possible.
Using a screwdriver, pry the selector lever cable end from the selector lever.
 Courtesy of FORD MOTOR COMPANY
|
- 11.
Remove the selector lever cable retainer.
 Courtesy of FORD MOTOR COMPANY
|
- 12.
Disconnect the selector lever cable retainer from the bracket.
 Courtesy of FORD MOTOR COMPANY
|
- 13.
Remove the nuts.Torque
: 80 lb.in (9 Nm)
 Courtesy of FORD MOTOR COMPANY
|
- 14.
Remove the bolts.Torque
: 71 lb.in (8 Nm)
 Courtesy of FORD MOTOR COMPANY
|
- 15.
Remove the wiring retainer.
 Courtesy of FORD MOTOR COMPANY
|
- 16.
Disconnect the electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 17.
Remove the wiring retainer and position aside the wiring harness.
 Courtesy of FORD MOTOR COMPANY
|
- 18.
Remove the selector lever assembly.
 Courtesy of FORD MOTOR COMPANY
|