Removal And Installation

WARNING: This page is about a different car, the 2016 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

1.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

2.

Recover the refrigerant. For additional information, refer to the A/C System Recovery, Evacuation and Charging procedure in Climate Control System - General Information and Diagnostics .

3.

Release the 4 underbody shield retainers and remove the underbody shield (if equipped).

GFD87602

Courtesy of FORD MOTOR COMPANY

4.

Remove the lower radiator splash shield.

GFD89265

Courtesy of FORD MOTOR COMPANY

5.

Remove the rear A/C compressor bolt.
- To install, tighten to 25 Nm (18 lb-ft).

6.

Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- To install, tighten to 20 Nm (177 lb-in).

7.

Remove the condenser inlet fitting nut and disconnect the fitting.
- To install, tighten to 15 Nm (133 lb-in).

8.

Disconnect the A/C pressure transducer electrical connector.

9.

Remove the compressor-to-condenser discharge line.

10.

To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.
- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure in Climate Control System - General Information and Diagnostics .

11.

Evacuate, leak test and charge the refrigerant system. For additional information, refer to Climate Control System - General Information and Diagnostics .