Seat - Second Row: Installation

LH inboard striker

1.

NOTE: LH seat inboard striker can be identified with large bolt holes.

Position the LH inboard seat striker to the floor and install the 2 bolts.
- Tighten to 80 Nm (59 lb-ft).

2.

Position the console bracket cover and install the 2 screws.

RH inboard seat striker

3.

Position the RH inboard seat striker to the floor and install the 2 bolts.
- Tighten to 80 Nm (59 lb-ft).

Outboard seat strikers

4.

Position the RH or LH outboard seat striker to the floor and install the 2 bolts.
- Tighten to 48 Nm (35 lb-ft).

RH 40 percent seat

NOTE: Make sure not to lean or apply any lateral pressure on the seat assembly when tightening the seat track-to-floor fasteners. Doing so may cause a binding condition which may adversely affect the operation of the seat.

5.

Position the seat in the vehicle and install the retainers.
1. 1.
  
  Install the riser/ seat track-to-floor pan rear inboard nut.
  - Tighten to 48 Nm (35 lb-ft).
1. 2.
  
  Install the riser/ seat track-to-floor pan rear outboard nut.
  - Tighten to 48 Nm (35 lb-ft).
1. 3.
  
  Install the riser/ seat track-to-floor pan front outboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
1. 4.
  
  Install the riser/ seat track-to-floor pan front inboard bolt.
  - Tighten to 48 Nm (35 lb-ft).

Courtesy of FORD MOTOR COMPANY

LH 40 percent and 60 percent seats

6.

Position the seat in the vehicle and install the retainers.
1. 1.
  
  Install the riser/ seat track-to-floor pan rear inboard nut.
  - Tighten to 48 Nm (35 lb-ft).
1. 2.
  
  Install the riser/ seat track-to-floor pan rear outboard nut.
  - Tighten to 48 Nm (35 lb-ft).
1. 3.
  
  Install the riser/ seat track-to-floor pan front outboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
1. 4.
  
  Install the riser/ seat track-to-floor pan front inboard bolt.
  - Tighten to 48 Nm (35 lb-ft).

Courtesy of FORD MOTOR COMPANY

All seats

7.

If equipped, connect the electrical connector(s).

8.

NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Check the seat for correct operation.
- With the seat in the upright position, both latch feet must lock to the strikers.
- When releasing the seat to the E-Z entry position, the latches must release freely and not bind to the strikers.

9.

If equipped with inflatable belts, repower the SRS. Refer to Supplemental Restraint System .