Transfer Case
WARNING: This page is about a different variant/trim than selected.
- 1.NOTE: The help of an assistant will be required.
Position the transfer case on the crossmember. Lower the transmission approximately 25.4 mm (1 in).
- 2.NOTE: The help of an assistant will be required.
Position the transfer case to the transmission and onto the output shaft.
- 3.NOTE: Do not reuse the old transfer case-to-transmission bolts.
Install new transfer case-to-transmission bolts.
Torque: 168 lb.in (19 Nm)
- 6.
Install the transmission support crossmember. Refer to: Transmission Support Crossmember .
- 8.
Connect the shift motor electrical connector and attach the harness retainer clip to the transfer case.
- 9.NOTE: Align the index marks made during removal.
Install the rear driveshaft. Refer to: Rear Driveshaft .
- 10.NOTE: Align the index marks made during removal.
Install the front driveshaft. Refer to: Front Driveshaft .
- 11.
Check the transfer case fluid level. Refer to: Transfer Case Draining and Filling .