Tie Rod End

• 1.
  
  Remove the wheel and tire. Refer to Wheels and Tires .

• 2.
  
  
  NOTE: Do not use a hammer to separate the outer tie-rod end from the wheel knuckle or damage to the wheel knuckle may result.
  NOTE: Use care when installing the tie rod separator or damage to the outer tie-rod end boot may occur.

  Separate the tie rod end from the wheel knuckle.

  • 1.
    
    Loosen the tie rod end jamb nut.
    • To install, tighten to 103 Nm (76 lb-ft).

  • 2.
    
    Remove and discard the tie rod end nut.
    • To install, tighten to 115 Nm (85 lb-ft).

  • 3.
    
    Using the tie rod separator, Separate the tie rod end from the wheel knuckle.

Courtesy of FORD MOTOR COMPANY

• 3.
  
  
  NOTE: Count and record the number of turns required to remove the outer tie-rod end for reference during installation.

  Remove the tie rod end.

Courtesy of FORD MOTOR COMPANY

Installation 

• 1.
  
  To install, reverse the removal procedure.

• 2.
  
  Check and if necessary, adjust front toe. Refer to Suspension System General Information .