Pinpoint Test X: Exhaust Pressure (EP) Sensor: Introduction

NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

harness circuits: EP, SIGRTN, VREF
EP sensor (9J460)
PCM (12A650)

Fig 1: Identifying Exhaust Pressure (EP) Sensor Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
3	EP (Exhaust Pressure)
1	SIGRTN (Signal Return)
2	VREF (Reference Voltage)

Fig 2: Identifying Powertrain Control Module-E (PCM-E) Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
58	EP (Exhaust Pressure)