LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Taurus SHO >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine - 3.5L Ti-VCT) >> In-Vehicle Repair >> Engine Mount >> Removal

Engine Mount: Removal

WARNING: This page is about a different variant/trim than selected.

  1. 1.

    With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

  1. 2.

    If equipped, release the 4 retainers and remove the underbody shield.
GFD82003Courtesy of FORD MOTOR COMPANY

  1. 3.

    If equipped, remove the 10 retainers and the skid plate.
GFD82004Courtesy of FORD MOTOR COMPANY

  1. 4.

    NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

    Position a floor jack with a block of wood under the front of the oil pan.

GFD82023Courtesy of FORD MOTOR COMPANY

  1. 5.

    Detach the A/C line retainer from the shock tower bracket.
GFD82098Courtesy of FORD MOTOR COMPANY

  1. 6.

    Using hose clamp pliers, pinch the lower degas bottle hose and remove the hose from the coolant inlet pipe.
GFD82017Courtesy of FORD MOTOR COMPANY

  1. 7.

    Remove the degas bottle. For additional information, refer to Engine Cooling .

  1. 8.

    Remove the 4 engine mount nuts.
GFD82024Courtesy of FORD MOTOR COMPANY

  1. 9.

    Remove the 3 bolts and the engine mount.
GFD82025Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals