Removal And Installation

1.

Drain the cooling system. For additional information, refer to Engine Cooling .

2.

If equipped, remove the 4 retainers and the underbody shield.

GFD82419

Courtesy of FORD MOTOR COMPANY

3.

NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

NOTE: If the vehicle is equipped with a skid plate, verify the piece of wood is clear of the skid plate.

Position a floor jack with a block of wood under the front of the oil pan.

GFD82023

Courtesy of FORD MOTOR COMPANY

4.

If equipped, remove the noise generator. For additional information, refer to Intake Air System Components - Exploded View in Intake Air Distribution and Filtering .

5.

Remove the engine coolant degas bottle. For additional information, refer to Engine Cooling .

6.

Disconnect the upper radiator hose from the intake manifold.

7.

Remove the A/C tube bracket bolt from the upper RH shock tower.
- To install, tighten to 15 Nm (133 lb-in).

8.

Remove the A/C tube retaining clamp bolt from the lower RH shock tower.
- To install, tighten to 9 Nm (80 lb-in).

9.

Remove the 4 engine mount nuts.
- To install, tighten to 63 Nm (46 lb-ft).

10.

Remove the 3 bolts and the engine mount.
- To install, tighten to 90 Nm (66 lb-ft).

11.

To install, reverse the removal procedure.

12.

Fill and bleed the cooling system. For additional information, refer to Engine Cooling .