LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Taurus SHO >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 3.5L GTDI >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

  1. 1.

    NOTE: Lubricate the valve stem seal with clean engine oil prior to installation.

    Using the Valve Stem Oil Seal Installer, install a new valve stem seal.

GFD82700Courtesy of FORD MOTOR COMPANY

  1. 2.

    Install the valve.

  1. 3.

    Using the Valve Spring Compressors, install the valve spring, retainer and key.
GFD82616Courtesy of FORD MOTOR COMPANY

  1. 4.

    Repeat the above steps for each valve.

  1. 5.

    Install the timing chain guide pin and/or timing chain tensioner arm pin and tighten in 2 stages.
    • Stage 1: Tighten to 20 Nm (177 lb-in).
    • Stage 2: Tighten an additional 60 degrees.

  1. 6.

    Install the turbocharger oil supply quick connect fitting.
    • Tighten to 16 Nm (142 lb-in).

  1. 7.

    If equipped, install a new CHT sensor.
    • Tighten to 10 Nm (89 lb-in).
scientia non olet · About LEMON Manuals