Lumbar Assembly Power: Removal
NOTE:
For parts identification and location, refer to Seat - Exploded View, Front in this article.
- 1.
Remove the seat backrest. For additional information, refer to Seat Backrest - Front in this article.
- 2.NOTE: Note wire harness routing for installation.
Disengage the backrest cover lower J-clips and route the wire harness(es) out of the hole(s) in the backrest cover.
- 4.NOTE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.
Separate the hook-and-loop strips and invert the backrest cover up to the first row of hog rings.
- 5.
If equipped, disconnect the backrest Thermo-Electric Device(TED) electrical connector and disengage the pin-type retainer.