Lumbar Assembly Manual: Installation

1.

Position the manual lumbar control and install new rivets.

2.

Engage the manual lumbar retaining clips and cable retainer.

3.

Roll the backrest cover down and attach the hook-and-loop strips.

4.

Route the wire harness through the hole in the backrest cover and engage the lower J-clips.
- Make sure the manual lumbar cable is routed out from the outboard side of the backrest cover before engaging the lower J-clips.

GFD85804

Courtesy of FORD MOTOR COMPANY

5.

On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.

GFD85792

Courtesy of FORD MOTOR COMPANY

6.

Install the seat backrest. For additional information, refer to Seat Backrest - Front in this article.