LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Escape S >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Control System - General Information >> Removal And Installation >> Climate Control Housing >> Removal

Climate Control Housing: Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the driver knee airbag. Refer to: Driver Knee Airbag .

  1. 2.

    Remove the bolt and the LH footwell duct.

    Torque: 27 lb.in (3 Nm)

GFD50701Courtesy of FORD MOTOR COMPANY

  1. 3.

    Remove the FCIM. Refer to: Front Controls Interface Module (FCIM) .

  1. 4.

    Remove the instrument panel. Refer to: Instrument Panel .

  1. 5.

    Remove the bolts and the evaporator housing bracket.

    Torque:

    1: 18 lb.ft (25 Nm)

    2: 133 lb.in (15 Nm)

GFD50702Courtesy of FORD MOTOR COMPANY

  1. 6.

    Disconnect the electrical connectors and detach the wiring harness retainers.
GFD50703Courtesy of FORD MOTOR COMPANY

  1. 7.

    Detach the wiring harness retainer.
GFD50704Courtesy of FORD MOTOR COMPANY

  1. 8.

    Disconnect the electrical connectors.
GFD50705Courtesy of FORD MOTOR COMPANY

  1. 9.

    If equipped.
    • Disconnect the electrical connectors.
GFD50706Courtesy of FORD MOTOR COMPANY

  1. 10.

    Open the glove compartment.
GFD50707Courtesy of FORD MOTOR COMPANY

  1. 11.

    Remove the screws and the glove compartment. Disconnect the electrical connector.

    Torque: 18 lb.in (2 Nm)

GFD50708Courtesy of FORD MOTOR COMPANY

  1. 12.

    NOTE: Upper retainer access is extremely difficult, the use of wobble extention and sockets are needed for removal of this retainer.

    Remove the climate control housing bolts.

GFD50709Courtesy of FORD MOTOR COMPANY

  1. 13.

    Disconnect the electrical connector and remove the in-vehicle temperature and humidity sensor.
GFD50710Courtesy of FORD MOTOR COMPANY

  1. 14.

    Remove the retainers and the air plenum bezel.

    Torque: 89 lb.in (10 Nm)

GFD50711Courtesy of FORD MOTOR COMPANY

  1. 15.

    NOTE: Upper retainer access is extremely difficult, the use of wobble extention and sockets are needed for removal of this retainer.

    Remove the climate control housing bolts.

GFD50712Courtesy of FORD MOTOR COMPANY

  1. 16.

    Remove the climate control housing.
GFD50713Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals