Remote Keyless Entry (RKE) Transmitter Programming

WARNING: This page is about a different car, the 2015 Ford C-Max. However, it is still accessible from the selected car via links, so may be relevant.

Programming

NOTE: All RKE transmitters must be programmed at the same time. Entering the programming mode erases all previously programmed RKE transmitters (Integrated Keyhead Transmitters (IKTs) and key fobs). The PATS portion of the programmed Integrated Keyhead Transmitters (IKTs) is unaffected.

1.

Use the door lock control switch to unlock the doors.

2.

Cycle the ignition from OFF to RUN to OFF 8 times in rapid succession (within 10 seconds), with the last turn ending in OFF. An anti-theft message briefly displays and a chime sounds.

NOTE: Programming mode ends when:

3.
- the ignition transitions ON.
- 10 seconds elapse since entering programming mode or since the last RKE transmitter was programmed.
Within 10 seconds, press and hold any button on the RKE transmitter to be programmed. Repeat this step for each RKE transmitter. As each RKE transmitter is programmed, the anti-theft message briefly displays and a chime sounds.

4.

Check the operation of the RKE transmitters.
- If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and press the button again. If the door locks still fail to respond, diagnose the RKE transmitter(s).

5.

Check the operation of the RKE transmitters.
- If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and press the button again. If the door locks still fail to respond, diagnose the RKE transmitter(s).