Repair procedures: Installation
WARNING: This page is about a different car, the 2014 Hyundai Elantra GT and 2013 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
- Install in the reverse order of removal.
- Before installing the pin, apply the grease to the joint pin.
- Use a new snap pin whenever installing.
- After installing, bleed the brake system.
(Refer to BRAKE SYSTEM BLEEDING )
- After be equipped perform bleeding air procedure in clutch release cylinder after pouring the brake fluid. [MT only]
(Refer to "CLUTCH RELEASE CYLINDER ")